The file I used was this: e3_downgrade.bin (TF e3downgrade to v1.2) so I downloaded the site e3 flasher was my original nand correct in the sd card, then who wrote the e3_downgrade.bin, and hung up and turned on the ps3 I would use amazebreak to put it into service mode, but when I turn on the ps3, it was already that way I spoke.
(I'm following the tutorial video, the site e3flasher)
Do you have any way to recover the ps3?
May want to check this out e3 flasher released some files today etc:
E3Flasher is so bad i prefer my Progskeet it work so fine also i have a professional flash programmer i'm using it to flash customers ps3 consoles also.
I got it unbrick, went back to work, but that with another brick, can not install ofw 4.00, to the end, reaches 60% of the error and restarts, and begins again, buy a progskeet, to make a ps3 in other tests.
Do you have a good tutorial step by step to downgrade the ProgSkeet?
With ProgSkeet is possible to recover the problem of red screen?
I'll just unstick it, if Kado wants to expand upon it he can
Yea GraVoX when i see him again i'll try to get more info to update this post.
But i hope that every body understand why KADO shared this with everybody even if it can be done easier using only QA flag and no body calling this patch is a bullshit since this patch lead to newer TB CFW.
Kado had released it to share some info with developers also to hint a syscon hash reset method for everybody so he hope that everyone learn from this patch.
When i see him again i'll update any info related to this topic also.
Hello, I have a CECH-2504B console which I updated to OFW 3.70. After that I wanted to downgrade the console to 3.55 TB dongle firmware with Progskeet chip, but I have problems getting it into factory service mode.
To get in in factory service mode, I use the AVRKey which I have used before. With Winskeet I created 3 coba flash files, created with the original dump and the 3 patch files.
When I wrote them to the PS3, I read them out and that were exactly the same.
But with every 3 coba flash files, the PS3 turns off after 1 second, when I turn it on. Only when I put the R8 open, then I keeps on, but cannot get it into factory service mode.