really need help please, going insane

[rory2005]

hi guys got a cech 2003a and trying to downgrade using progskeet 1.1. soldered

i can dump fine and flash fine.

however when i try to enter fsm mode all i get is connect controller screen, im using a minimus v1 with ps grade at90usb162.hex, but everytime i power and eject i get both green and red light then after a few seconds the red switches off and is replaced by the blue led, but ps3 doesnt power down.

going from fw4.21 to 3.55
6 dumps, checked with hxd, ps3 boot with orig dumps

these are my dumps, 1st is untouched second is patched, what am i doing wrong?

https://rapidshare.com/files/2260015661/1.bin

https://rapidshare.com/files/118028/1.patch.bin

what am i doing wrong, and if my patched nor is wrong can someone correct it and let me know where ive gone wrong!

[windrider]

I don't know much about progskeet, only e3flasher, but when you get the screen

"Connect a controller using a USB cable, and then press the PS Button"

This is where you shut off your PS3 at the back or unplug it.

Then insert your dev usb board (programmed with the correct files) into the right usb slot.

Turn the ps3 back on then immediately press eject within ~200ms. Your console will turn on and if your dev usb has led's then the dongle will light up the red LED followed by the green LED and turn back off.

You should then be in FSM, and can continue the tutorial you are following.